共搜索到11365条信息,每页显示10条信息,共1137页。用时:0小时0分1秒172毫秒
......
J. Cent. South Univ. (2017) 24: 1754-1761 DOI: https://doi.org/10.1007/s11771-017-3583-9 Effect of applied load on transition behavior of wear mechanism in Cu-15Ni-8Sn alloy under oil lubrication... was investigated on a ring-on-block tester in oil lubrication. The results showed that the wear rate increased slowly from 1.7×10-7 to 9.8×10-7 mm3/mm under the load lower than 300 N......
is 0.266. These properties make such composite suitable for use as self-lubricating material. Key words:activated sintering; Ni-Cr/BN; composite; solid lubrication material1 Introduction In modern... of insufficient density changed little,too long, unable to provide further density. Warming up speed for 10-14 ℃/min is suitable. References [1] MATSUO M. Solid manual lubrication[M]. FAN Yu......
composites were summarized. The lubrication mechanism of metallic solid self-lubricating composite was discussed. The problems in the research and development of metallic solid self-lubricating composite...空间,更好地服务于各行各业. REFERENCES [1] 王海斗, 徐滨士, 刘家浚. 固体润滑摩擦技术与应用[M]. 北京: 国防工业出版社, 2009: 6-74, 273-275. WANG Hai-dou, XU Bin-shi, LIU Jia-jun. The solid lubrication technology and application [M]. Beijing......
......
stability of Ag[5]. Therefore, Ag-Pd alloy is considered a solid lubricant in order to obtain the superior properties of lubrication and durability at once. In this work, the lubrication property... Lubrication properties of silver-palladium alloy prepared by ion plating method for high temperature stud bolt Jung-Dae KWON1, Sunghun LEE1, Koo-Hyun LEE1, Jong-Joo RHA1, Kee-Seok NAN1, Se......
on the solid interface, the thickness h of the grease-lubrication film is very small and the pressure change along the film thickness in the direction r of Figure 4 is ignored, and the lubricant..., JI Hong, YANG Jian. Research on lubrication mechanism with fluid–solid coupling of port plate pair in swash plate axial piston pump[J]. Proceedings of the Institution of Mechanical Engineers, Part J......
tensile strength is 24.8 MPa, wear rate reaches 74.4 μg/min, and the average friction coefficient is 0.266. Key words: active sintering; Ni-Cr/BN; composites; solid lubrication  ..., 1986.Matsunaga M. Manual of solid lubrication[M]. FAN Yu, transl. Beijing: China Machine Press, 1986. [2] 刘如铁, 李溪滨. 镍基高温自润滑材料[J].粉末冶金材料与工程, 1997, 2(1): 32-38.LIU Ru-tie, LI Xi-bin. Nickel-base high......
Trans. Nonferrous Met. Soc. China 22(2012) 2431-2438 Lubrication properties of Nitinol 60 alloy used as high-speed rolling bearing and numerical simulation of flow pattern of oil-air lubrication... lubrication conditions. It was found that Nitinol 60 alloy can be lubricated well and has shown remarkable tribological performance. Average coefficient of friction (COF) of Nitinol 60 is 0.6 under dry......
......