共搜索到10246条信息,每页显示10条信息,共1025页。用时:0小时0分1秒201毫秒
Geophysica, 2016, 64(5): 1916-1941. DOI: 10.1515/acgeo-2016-0047. [3] SHANBHAG V V, MEYER T J, CASPERS L W, SCHLANBUSCH R. Condition monitoring of hydraulic cylinder seals using acoustic emissions [J......
. According to the calculation of the overburden load in the actual soil engineering, the maximum load of the test was equal to 400 kPa. Under the side limit condition, the saturated ring cutter specimens......
to 41.85°. Under this condition, the contact angle of Cu-activated sphalerite (41.85°) and the contact angle of Cu-activated sphalerite treated by PAPA (36.87°) were not much different. These results......
. Equation (10) is sufficient condition to claim the nanostructural characteristics and thermodynamic process of the interaction between LSCO nanoparticles within the cement system. Therefore......
] XIAO Jia, WANG Jian-hua, CHEN Lei, ZHAO Jin-hui. Damage mechanism of cement-ground limestone cementitious material under sulfate attack condition [J]. Journal of Central South University......
iterations is less than 0.01, the convergence condition is considered to be satisfied. In many experiments, we found that the best fitness value in each iteration does not always keep getting smaller......
on improved soil attracted many scholars’ attentions [29, 30]. Their findings show that dry-wet cycle and freeze-thaw cycle have great influence on the strength and deformation characteristics. Some... characteristics of improved soil under the dry condition, while the influence of water on the improved soil was ignored. Polymer is widely used in river bank slope reinforcement and ecological slope......
. Research on fresh air status of marine air condition system[J]. Mechanical and Electrical Equipment, 2014, 31(1): 37-39. [15] 陈安扬. 暖通新技术在医院船上的应用[J]. 上海造船, 2009, 25(4): 9-11. CHEN Anyang. Application......
softening during high-temperature plastic deformation. In practical application, the flow stress value of the material under any deformation condition can be obtained if the material constants (A1, Q, β......
%, which was higher than that of the AP65 series alloys [31] and the Mg-Ca binary alloy [10] under the same test condition. One of the factors responsible for the utilization efficiency of magnesium anodes......