共搜索到16349条信息,每页显示10条信息,共1635页。用时:0小时0分0秒352毫秒
......
process. The layout size is 326.675 μm × 367.27 μm. It is confirmed by the computer simulation that the power dissipation is 11.82 μW in read mode, 25.15 μW in the program mode, and 24.08 μW in the erase...J. Cent. South Univ. Technol. (2011) 18: 2036-2044 DOI: 10.1007/s11771-011-0939-4 Design of 512-bit logic process-based single poly EEPROM IP JIN Li-yan(金丽妍), JANG Ji-Hye, YU Yi-ning(余忆宁), HA Pan......
......
......
J. Cent. South Univ. (2017) 24: 637-646 DOI: 10.1007/s11771-017-3464-2 Design of motion control system of pipeline detection AUV JIANG Chun-meng(姜春萌), WAN Lei(万磊), SUN Yu-shan(孙玉山) Science... that not only examines the logical rationality of the program, effectiveness of the hardware architecture, accuracy of the software interface protocol as well as the reliability and stability of the control......
J. Cent. South Univ. Technol. (2011) 18: 946-952 DOI: 10.1007/s11771-011-0785-4 Design methods of headed studs for composite decks of through steel bridges in high-speed railway HOU Wen-qi(侯文崎...: Aimed at two typical composite floor systems of through steel bridges in high speed railway, design methods of headed studs were put forward for different composite members through comparing......
......
was proposed. For optimal design of the proposed V-type model, changes in the characteristics due to changes in length were analyzed by using the FEM program. Similarly, the model generating maximum...J. Cent. South Univ. Technol. (2010) 17: 1247-1250 DOI: 10.1007/s11771-010-0627-9 Optimal design of V-type ultrasonic motor JEONG S S, PARK C H, PARK T G School of Mechatronics, Changwon National......
......
point distribution by uniform design computer program. And each factor is divided into three levels. The Ni and Co contents are in the nominal chemical composition. Table 1 Experimental point... content, soldering temperature and time on the IMC thickness in Sn-3Ag-0.5Cu and Sn-3Ag-0.5Cu-0.2Co alloys were researched using uniform design method and computer programs. For each alloy, the factors......