Prediction of Springback in Long Channels
来源期刊：Acta Metallurgica Sinica2015年第12期
论文作者：Chetan P.Nikhare
文章页码：1525 - 1531
摘 要：Sheet metal forming is one of the most preferred manufacturing processes in automotive and aerospace industries. However, due to increase in fuel prices and more stringent environmental regulation, these industries are facing many challenges to meet the criteria. Due to this, many efforts in design and manufacturing were considered and presented.Those efforts were implementing lighter-weight materials like aluminum and magnesium（but they have higher elasticity as compared to steel） and implementing higher-strength steel with lower thickness. The main challenge found in both cases is springback after deformation. Springback is the elastic recovery after the part is unloaded. In this paper, the 3D channels with large length were deformed numerically and springback at different section was predicted. For this purpose, tailorwelded blank was considered. The geometric change along the long axis was also discussed. In addition, the effect of flange springback on wall springback was also analyzed. It was found that different section produced different springback and greater influence of flange springback. To validate the numerical simulation approach, the experiments on one case were performed and compared.
Chetan P.Nikhare
Mechanical Engineering, Penn State Behrend
摘 要：Sheet metal forming is one of the most preferred manufacturing processes in automotive and aerospace industries. However, due to increase in fuel prices and more stringent environmental regulation, these industries are facing many challenges to meet the criteria. Due to this, many efforts in design and manufacturing were considered and presented.Those efforts were implementing lighter-weight materials like aluminum and magnesium（but they have higher elasticity as compared to steel） and implementing higher-strength steel with lower thickness. The main challenge found in both cases is springback after deformation. Springback is the elastic recovery after the part is unloaded. In this paper, the 3D channels with large length were deformed numerically and springback at different section was predicted. For this purpose, tailorwelded blank was considered. The geometric change along the long axis was also discussed. In addition, the effect of flange springback on wall springback was also analyzed. It was found that different section produced different springback and greater influence of flange springback. To validate the numerical simulation approach, the experiments on one case were performed and compared.
关键词：
